Panasonic KX-G8300 Service Manual And Technical Manual page 14

LO let sKiN0)
10. The following plugs are connected at the factory.
Make sure the connections are tight and proper.
(1) CN 603 (6-pin) on the receiver PCB and CN 802 (6-Pin) on the transmitter PCB
(2) Motor base and CN 804 (3-pin) on the transmitter PCB
(3) Motor base and CN 801 (5-pin) on the transmitter PCB
CN 802 (6-pin)
11. Leaving a little less than one and half inch of the cable (before the break out) exposed above the clamping plate, replace
the four screws and tighten down the plate.
Make sure the rubber gasket seals well around the cable.
To be tied the ground wire with screws as following picture.
Ground Wire
| 1.19" (3em)
Cable clamping plate
Fig. 13
NOTE:
Take care not to expose too much cable above the plate because it may be hit by the antenna's rotation.