Table of Contents
Advertisement
I
installation
Step 1: Connect the Fuse Tap Cable to the fuse
box.
1.1
Find
your vehicle's fuse box.
Typically
it
locates under the driver
steering wheel or underneath your engine hood. Please refer your
vehicle manual.
1.2
Remove an original fuse associated with your vehicle's
ignition
ACC/Switched
or
Permanent power supply.
We recommend that the maximum rating of the fuse is no more
than 20 Amps. Please refer your vehicle manual.
1.3
There is a 2 Amp fuse (Item 5)
built
in the socket for 2 Amp fuse
tap cable (Item 6) which protects the dash cam.
Please
do not
remove or
change
it.
1.4
Choose the correct fuse tap
cable
from the three supplied types.
Plug in the original fuse to the socket for the original fuse (Item 7).
Plug
in the
Fuse Tap
Cable to the socket where the original fuse
was removed from
the
fuse box on Step
1.2.
Step 2:
Car Power Cable Installation
2.1
Mount
the dash cam behind the rearview mirror and
connect
the
SV
Mini USB
connector
(Item
1)
to the dash
cam.
2.2
Beginning with the dash cam end, tuck the car power cable
into
the headliner and hide the power cable along the A-pillar to the
rubber trim by using a pry/trim removal tool to
loosen
any trim.
Make sure there is still enough cable for dash cam
connections.
2.3
Keep lining the cable to the fuse box. Once you have the cable to
the fuse box, look for the ground around the area of the fuse box.
We recommend you ground the negative(-) spade connector
(Item 3) to a bolt on unpainted bare metal.
Next,
plug in the
positive(+)
car
power bullet
connector
(Item
4)
to the positive(+)
fuse tap cable bullet
connector (Item
8), and
it
will enable the
dash cam to
receive
power. Organize any excess cable by using
a cable clip to a convenient position.
03
Advertisement
Table of Contents
