Transporting Machines - Toro 30487N Operator's Manual

each side of the unit (Figure
the tractor frame extends back between the rear wheels and
serves as a stop for tipping backward. Having a full-width
ramp provides a surface for the frame members to contact if
the unit starts to tip backward. If it is not possible to use one
full-width ramp, use enough individual ramps to simulate a
full-width continuous ramp.
The ramp should be long enough so that the angles do not
exceed 15 degrees (Figure
mower components to get caught as the unit moves from
ramp to trailer or truck. Steeper angles may also cause the
unit to tip backward. If loading on or near a slope, position
the trailer or truck so it is on the down side of the slope and
the ramp extends up the slope. This will minimize the ramp
angle. The trailer or truck should be as level as possible.
Important: Do not attempt to turn the unit while on the
ramp; you may lose control and drive off the side.
Avoid sudden acceleration when driving up a ramp and
sudden deceleration when backing down a ramp. Both
maneuvers can cause the unit to tip backward.
WARNING
Loading a unit onto a trailer or truck increases the
possibility of backward tip-over and could cause
serious injury or death.
• Use extreme caution when operating a unit on
a ramp.
• Use only a single, full-width ramp; Do not use
individual ramps for each side of the unit.
• If individual ramps must be used, use enough
ramps to create an unbroken ramp surface wider
than the unit.
• Do not exceed a 15 degree angle between ramp
and ground or between ramp and trailer or truck.
• Avoid sudden acceleration while driving unit up
a ramp to avoid tipping backward.
• Avoid sudden deceleration while backing unit
down a ramp to avoid tipping backward.
35). The lower rear section of
35). A steeper angle may cause
1. Trailer
2. Full-width ramp

Transporting Machines

WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can lead
to accidents causing personal injury.
Do not drive machine on a public street or roadway
without signs, lights, and/or markings required by
local regulations.
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary lighting and
marking as required by law. Please carefully read all the safety
instructions. Knowing this information could help you or
bystanders avoid injury.
To transport the machine:
•
Ensure that your vehicle, hitch, safety chains, and trailer
are adequate for the load you are pulling and that they
meet all local traffic regulations for your area.
•
Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes as required by local traffic
regulations in your area
32
Figure 35
3. Not greater than
15 degrees
4. Full-width ramp—side
view
(Figure 36).