Advertisement
Quick Links
STEREO SYSTEM
RACK
KENWOOD
@PRINTED IN U.S.A B6i-0130-00(K)(TCA)
RO142
.
IMPORTANT:
—_—
gaa
ee
* Before operating your new KENWOOD
product, read through this assem-
bly manual carefully to get the most out of it.
¢ Save this assembly instructions.
Before Assembling
* Be sure to check that all parts are accounted for before disposing of the
packing case.
* A Phillips screwdriver and a mallet are required for assembling.
* Be carefull not to damage the floor and rack.
-Notes on Assembling
During assembling, be sure to verify the numbers stamped on the boards.
Mount the rear panel after assembling the side panel on the bottom shelf
at a right angle.
When mounting the top shelf and kick plate on the side panel, use glue
for adhesive. Be sure to remove any excess glue before it dries.
If the amplifier wobbles when its key switches are pressed, insert a woo-
den dowel into the hole on the side panel and fix the rear of the amplifier.
Handling Precautions
Tempered glass is used for the glass doors for providing sufficient strength.
However, pay attention not to apply excessive force or to scratch the doors.
Cracking or breaking of the glass may occur.
When moving the cabinet, remove all the components from the rack be-
fore carrying the cabinet. Also do not grasp the top shelf when carrying.
To allow head radiation from the components, leave a space of 4 inches
between the cabinet and wall.
:
Do not place the cabinet in a location subject to direct sunlight or near a
heater, an air-conditioner, or a place with high humidity.
¢
Cleaning Instructions
Clean the cabinet with a damp cloth and mild detergent.
Dimensions
Unit: inch (mm)
41%
(1,042)
3-5/16"
(84)
(20)
Net Weight: 60 Ibs (27 kg)
Advertisement
