AFTER INSTALLATION
28
AFTER INSTALLATION
Installation Instructions
How to Enter Installer Setting Mode
Installer setting mode set the detail function of the remote controller.
If the installer setting mode does not set correctly, it can cause problems to the product, user injury or
property damage.
This must be set by an certificated installer, and any installation or change that is carried out by a non-
certificated person should be responsible for the results. In this case, free service cannot be provided.
1
Press MODE and RESET button simultaneously.
2
Press
a
,
b
button for setting function code and value refer to the installer setting code table on the
next page.
3
After setting the address, press the
4
The indoor unit will display the set address to complete the address setting.
t
button toward the indoor unit 1 time.