Advertisement
4 After one minute and 50 seconds have elapsed, the device will be automatically shut off.
(Automatic shutoff function)
●
The finish sound (beep beep) will inform you.
When the "COOL" mode is finished, the main body and the cooling head become
●
slightly hot, however this is not unusual.
5 After use, make sure to pull out the power adaptor from the electric outlet and the main
body. (Fig.7)
●
If a toner/moisturizing product remaining on the skin attaches to the cooling head or
the main body, please wipe off with a tissue.
●
The power adaptor may become slightly hot during use, however this is not a device
failure.
CAUTION
If all of the mode indicator lamp and the level indicator lamp start flashing and the
abnormality detection sound beeps during use, this is a warning of device failure.
Pull out the power adaptor from the electric outlet, and contact the distributor for
repair.
About skin sensing function
●
This device is a product which operates through the human body. Applying the skin to
the back plate and the head will make an electrical circuit start to operate.
Unless you touch the back plate and apply the head to the skin, it will not start to operate.
Care for main body
●
Wipe off the toner on the head and the body with a tissue.
●
When dirt is difficult to remove, wipe it off with a cloth after saturating it with water and
wring it thoroughly.
Do not clean the main body with water. Or do not dip in water,
and do not pour water. (Cause of failure)
Make sure to pull out the power adaptor from the electric outlet.
(Improperly turning on the switch may give a tingling sensation or
result in malfunction or short-circuit.)
★Do not use alcohol, benzine, or thinner.
CAUTION
(Cause of deformation or discoloration)
How to preserve
●
Store the device on the included stand in a place free from excessive humidity or dirt.
●
The stand can store the rings in it as well as put the body on it. (Fig.13)
Do not leave in a water splashing area or an area with significant
humidity, such as a bath. (Cause of short-circuits or failure)
Do not wind the power cord around the power adaptor or the main
body. (Cause of damage to cord)
★Do not leave in an area subject to direct sunlight (inside of a vehicle in
CAUTION
summer, etc.) or near heaters. (Cause of deformation or discoloration)
Specifications
Rated voltage
100 - 240V AC, common to 50-60Hz
14W (Power adaptor : KH-186B)
Rated power input
-13-
Power consumption
Step 1.2.3
Step 4 (COOL) Approximate 13W (Room temperature 25 ℃)
Around 11 minutes at the maximum
Operating time
Mass
Main body : Approximately 150g
Power adaptor : Approximately 120g
Accessories
Rings (two), Stand
Disposal of the product
Do not disassemble except when disposing of the product.
This product includes recyclable parts.
For disposal of the parts, observe your local laws and regulations etc.
CAUTION
Make sure to pull out the device plug from the main body after using.
Do not store it when the power adaptor is connected with the main body or the cord is
wound around the main body. (Result in damage of the cord)
Do not wind the cord around
the main body.
Device plug.
※
Make sure to pull out the device plug
from the main body after using.
(Make sure to holding the plug to pull
out from main body.)
Do not keep the device plug and cord in a state of bending.
Approximate 4.3W (Room temperature 25 ℃)
Cord
-14-
Advertisement
