Equipment Required - HP 61010A Owner's Manual

Introduction Verification procedures for your Digital I/O are included
with your HP PC Instruments software. Instructions on
how to load and run these procedures are given in
Appendix B of your System Owner's Manual. When you
run the verification program, step-by-step instructions
appear on your computer's display to guide you through
each procedure. This appendix specifies the required test
equipment and briefly describes the tests performed on the
Digital I/O.
Equipment
Required
You must have an installed PC Instruments Interface Card
and a PC Instruments Digital I/O. You will also need the
third 25 pin, male D subminiature connector that was
included with your Digital I/O connector package for
verification. To perform the verification, you must install
this male connector in the INPUT connector socket on the
front of your Digital I/O. The other two connectors are
used for your application connections. In addition to the
connector, you must supply two dip leads to make the test
connections from the input to the output connector socket.
What the
When you first run the verification program, it does a
Test Does
system level verification that partially tests all the
instruments in your system. This part of the test checks
that the interface and instruments respond to commands
issued by the computer. This part of the test is described
in Appendix B of your System Owner's Manual.
Verification Procedures B-1