Installation; Electrical Installation - Bosch HBL33 Installation Manual

Installation
Electrical Installation
All model ovens on the front cover are dual rated, designed
to be connected to either 208/240V AC, 60 Hz, 4 wire,
single-phase power supply.
Model Circuit Required
208V, 60 Hz 240V, 60 Hz
HBL33, HBN34,
HBL34 25 AMP 30 AMP
HBN54, HBL54 30 AMP
HBL84
HBN35, HBL35 40 AMP
HBNS6, HBLS6, 30 AMP 40 AMP
HBL8&650,
HBLS/,
HBL8750 50 AMP
The electrical supply should be a 4-wire single-phase AC.
Install a suitable conduit box (not furnished). An
appropriately-sized, UL-listed conduit connector must be
used to correctly attach the conduit to the junction box.
Important: Local Codes may vary; installation, electrical
connections and grounding must comply with all applicable
local codes.
If local codes permit grounding through the electrical
supply neutral, connect both the white neutral wire and the
bare ground wire from the oven to the white neutral
electrical supply wire.
Electrical Connection
The four-wire connection is preferred, but where local
codes permit, the three wire connection is also acceptable.
English 12
Four-wire Connection
Cable from
Junction box —
oN power supply
White wires
Red wires se
Ungrounded Neutral
j a Black wires
j Bare or green wires Cable NN
from oven ™ U.Lelisted conduit connector
* Connect the red oven wire to the red electrical supply
wire (hot wire).
* Connect the black oven wire to the black electrical
supply wire (hot wire).
* « Connect the white neutral oven wire to the white
neutral (not bare ground) electrical supply wire.
* Connect the bare ground oven wire to the bare ground
electrical supply wire.
Three-wire Connection
Cable from
power supply
Junction box
White wires
Black wires
Bare or green wire
Cable U. Listed conduit connector
from oven
* Connect red wire from oven to red wire injunction box.
* Connect black wire from oven to black wire in junction
box.
* Connect both green ground wire and white wire from
oven to white (or gray) neutral wire in junction box.
The conduit cable, where connected at the oven, swivels.
Rotate conduit cable upward (or downward) and direct
through hole prepared in cabinet to attach to J-Box.
To maintain serviceability, the flex conduit must not be
shortened and should be routed to permit temporary
removal of the oven.