Hitachi PSC-A32MN Installation And Operation Manual page 60

Operation
5.3.4 Adjustment of the setting temperature range of the remote control
1 Select "Setting temp range of the remote control" at the "Menu" screen.*
* Selection is not possible in case that the connected air conditioners do not support this function.
2 Select the target for setting of temperature range. (All Groups/Block/Group)*
• The buttons of the groups with temperature range settings are shown in blue.
• The buttons of the groups in which temperature range setting is not available are shown in grey.
• The buttons of the groups with no temperature range settings remain inactive.
• Do not apply settings in groups using a wireless receive kit, since it is possible to set temperatures outside of the setting range
from a wireless remote control switch.
The following cannot be selected:
- Groups without a remote control switch
- Groups in which the representative remote control switch group is not a standard unit supporting H-LINK II (setting
temperature range is from 19 to 30 degrees for cooling, and from 17 to 30 degrees for heating).
3 Tap " " or " " to set the minimum setting temperature for cooling and/or the maximum temperature for heating.
4 Tap "Setting completed" to confirm the content of settings and to return to the selection screen.
5 Tap "Cancel" to discard the displayed settings and return to the selection screen.
52 PMML0332A rev.0 - 05/2015
(1)
(2)
(3)
(4) (5)