Maintenance - Toshiba RC-10ISSHK User Manual

Maintenance

Note
During maintenance, the power plug
should be unplugged. The body
should be maintained after cooling.
Otherwise, it will cause scald
After using inner cooking pot, removable cover plate, steam valve and serving spatula and
measuring cup getting dirty every time
Wash with sponge and neutral detergent for kitchen
Body • Main temperature controller
Please do not wash the entire body.
Please do not spray water to operating parts or covers, or
add water into the outer casing cover.
Please do not pull or drag washer of steam vent.
When there is dirt on temperature sensor
Opening buckle plate, suction port and exhaust port (bottom of the body)
Clean up foreign matters or dusts with cotton rod or others.
Steam
Clean inside steam valve
valve
Steam valve
cover
Steam valve
base
Movable
Clean inside steam valve
cover plate
Please note
Please do not use the following items
(Otherwise, it will cause deformation, corrosion, discoloration, crack or scratch)
Tableware washing dryer and tableware dryer
Detergent other than neutral detergents for kitchen
Gasoline, thinner, alcohol, cleanser and bleach
Grinding surface of nylon pot-scouring brush, melamine sponge and other
items easily causing scratch
Opening buckle plate
Dirt in steam valve will cause rice scent and spill.
Besides, there may be water drops in the case of spilling or opening the upper housing.
There will be water generated from cooled steam inside steam valve. If any water, there may be water
drops when opening upper housing. (Since water in steam valve is hot after using, maintain after the
body is cooled down)
Refer to page 8 for the method of disassembly.
Clean up attached foreign matters with bamboo stick or toothpick
Failing to wash clean will send out unpleasant odor. Therefore,
please keep it clean.
Wash the removable cover plate promptly after adding seasoning for
cooking. Otherwise, it will get rusty.
Movable
cover plate
"After use, please clean it. " The top
housing can't be closed without a
movable cover.
Sealing ring
(remove foreign matters)
Inner pot
Outer cover
Open button
holder
Suction port and exhaust
port (bottom side)
Suction port and exhaust port
Cover plate
button
Temperature sensor of
upper housing
Insulation base
Plug socket (rear face)
19