Check Accumulator Function, Gas Leakage, Looseness, And Damage - Hitachi ZW140-6 Operator's Manual

Wheel loader
Table of Contents

Advertisement

Check Accumulator Function, Gas Leakage,
Looseness, and Damage
--- every 500 hours
d
WARNING:
 Allow only qualified personnel to handle the
accumulator.
 High-pressure nitrogen gas is enclosed in the
accumulator. Caution is required to prevent fires
from occurring.
 Never strike the accumulator. Keep the accumulator
away from sparks and/or flames.
 Do not directly heat the accumulator. Do not weld
the accumulator housing.
 Be sure to release pressure before starting to work
on the pipe lines.
1. Precheck that alarm function is activated:
Precheck that when the brake pedal is strongly stepped
more than 5 strokes with the key switch ON and the
engine stopping, the monitor indicators come ON.
2. Precheck that alarm function is deactivated:
Start the engine. Run the engine at middle speed to
pressurize the accumulator. When the pressure builds in
the accumulated in the accumulator, the alarm buzzer
stops sounding and the brake oil pressure indicator goes
OFF.
3. Note how many times the brake pedal is stepped:
Check that the brake pedal can be stepped more than 5
strokes before the monitor indicators come ON with the
key switch ON and the engine stopping.
Three points described above must be normally
confirmed. Besides the above points, check the
accumulator for gas leakage, looseness, and damage.
If any abnormality is found, immediately consult your
authorized dealer.
MAINTENANCE
7-89
MNDF-07-030

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zw150-6Zw150pl-6

Table of Contents