Table of Contents
Advertisement
Storage
Storage Safety
•
Allow the machine to cool before storing.
•
Do not store the machine or fuel near flames.
Storage
Service Interval: Before each use or daily
Yearly or before storage
Yearly or before storage
1.
Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
grinder.
2.
Shut off the engine and remove the key.
3.
Remove dirt and grime from the external parts of
the entire machine, especially the engine. Clean
dirt and chaff from the outside of the engine
cylinder head fins and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
control panel, engine, hydraulic pumps, and
motors.
4.
Service the air cleaner; refer to
Cleaner (page
23).
5.
Grease the machine; refer to
Machine (page
22).
6.
Change the crankcase oil; refer to
Engine Oil (page
7.
Remove the spark plug and check the condition
of it; refer to
Servicing the Spark Plug(s) (page
26).
8.
For storage over 30 days, prepare the machine
as follows:
A.
Add fuel stabilizer/conditioner to fresh fuel
in the tank. Follow the mixing instructions
from the stabilizer manufacturer. Do not
use an alcohol-based stabilizer (ethanol or
methanol).
B.
Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C.
Shut off the engine, allow it to cool, and
drain the fuel tank using a pump type
syphon.
D.
Start the engine and run it until it shuts off.
E.
Engage the choke.
Servicing the Air
Greasing the
Changing the
25).
F.
Start and run the engine until it does not
start again.
G.
Dispose of fuel properly. Recycle as per
local codes.
Important:
Do not store fuel containing
stabilizer/conditioner longer than the
duration recommended by the fuel-stabilizer
manufacturer.
9.
With the spark plug removed from the engine,
pour 2 tablespoons of engine oil into the
spark-plug hole.
10.
Place a rag over the spark-plug hole to catch
any oil spray, then use the starter or recoil
handle to crank the engine and distribute the oil
inside the cylinder.
11.
Install the spark plug, but do not install the wire
on the spark plug.
12.
Charge the battery; refer to
(page
29).
13.
Check and adjust the track tension; refer to
Checking and Adjusting the Track Tension (page
31).
14.
Check and tighten all fasteners. Repair or
replace any part that is damaged.
15.
Paint all scratched or bare metal surfaces with
paint available from your Authorized Service
Dealer.
16.
Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place.
17.
Cover the machine to protect it and keep it clean.
41
Charging the Battery
Advertisement
Table of Contents
