Figure 53
1. Transmission-case-drain
plug
2. Filter
4. Clean the area around the hydraulic-fluid filter and
remove it
(Figure
53).
5. Immediately install a new hydraulic-fluid filter.
6. Install the hydraulic reservoir and transmission case
drain plugs.
7. Fill the reservoir to the proper level (approximately 17
L or 18 US qt); refer to
(page
50).
8. Start the engine and check for leaks. Allow the engine
to run for about 5 minutes, then shut it off.
9. After 2 minutes, check the level of the hydraulic fluid;
refer to
Checking the Hydraulic System (page
3. Hydraulic-reservoir-drain
plug
Checking the Hydraulic System
50).
Cab Maintenance
Filling the Washer-Fluid Bottle
1. Perform the pre-maintenance procedure; refer to
Preparing the Machine for Maintenance (page
2. Open the hood and locate the washer-fluid bottle
(Figure
54).
g014393
Washer-Fluid Bottle with Washer-Fluid Symbol
3. Fill the bottle with washer fluid as needed.
4. Close the hood.
Cleaning the Cab Air Filters
Service Interval: Every 250 hours Replace the cab air filters
1. Remove the screws and grates from over both the
in-cab and rear cab air filters
51
Figure 54
if they are torn or excessively dirty.
(Figure
55).
36).
g028438