Registering An Additional Adapter - Sharp HN-VA401SU Operation Manual

Registering an Additional Adapter

If you purchase an additional adapter, follow the steps below to register
the adapter. The new adapter cannot be used until it is registered.
♦
Up to 16 adapters can be used on one network.
1
Plug the new adapter into an outlet next to one of the existing adapters.
• Check the PLC indicator on the existing adapter and make sure it is solidly
lit or blinking (registration is not possible if the existing adapter is not able to
communicate normally on the network).
Existing adapter
2
Hold down the SET button on the existing adapter for about 2 seconds and
then release it.
• When you release the SET button, the POWER indicator will blink.
• Do not hold the SET button down too long (if it is held down for about 10
seconds, the registration will be cleared).
Registering an Additional Adapter
SET
New adapter
11