Page 1
OWNER’S MANUAL Dome Camera Please read this manual carefully before operating your set and retain it for future reference. MODEL LT303N/P LT303NI/PI LT303N/P-U P/NO : MFL66987622 LT303P-B.HAP_ENG_MFL66987622.ind1 1 2011.1.4 6:48:44 PM...
Page 2
• A suitable conduit entries, knock-outs or glands CAUTION shall be provided in the cable entries of this prod- RISK OF ELECTRIC SHOCK uct in the end user. DO NOT OPEN • Caution: Danger of explosion if battery is incor- rectly replaced.
Page 3
EEE Compliance with Directive. (for Turkey only) outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience LG Electronics hereby declares that receptacles, and the point where they exit from this/these product(s) is/are in com- the apparatus.
Contents Reference .............. Specifications ............33 Introduction ...............5 About Dome Camera ..........5 Features ..............5 Safety Precautions ..........6 Identification of Camera ........7 Installation ...............10 Installation Precautions ........10 Removing the Protection Tape ......10 Mounting the Camera ......... 11 Dipswitch Setting ..........15 Camera ID Setting ..........16 Connections ............19 Precautions ............19 Connection preview ..........19...
Privacy Mask Introduction Privacy zone feature enables users to veil unwant- ed zones. This setting is used for masking unwant- ed zones, hiding them from display on the monitor screen. Up to 8 zones can be registered. About Dome Camera Auto Pan The camera has an Auto Pan function that enables to keep surveillance on every detail occurring...
Day & Night Function Rapid temperature fluctuation due to frequent • This camera can be selected Color or Black & door opening and closing. White. You can set Color in the daytime and Black Use in an environment where eyeglasses •...
Identification of Camera LT0N/LT0P a Camera mounting bracket b Dome camera body c Dome cover assembly d Video output cable with BNC connector “A” Connects with the video connector of the monitor. e Power cable (DC 1 V) f Data Communication Port (RJ45) - RS-485 and Alarm Input g Data Communication Port (RJ45) - RS-485 and Alarm Input...
Page 8
LT0NI/LT0PI a Camera mounting bracket (Optional) b Dome camera body c Dome cover assembly d Video output cable with BNC connector “A” Connects with the video connector of the monitor. e Power cable (DC 1 V) f Data Communication Port (RJ45) - RS-485 and Alarm Input g Data Communication Port (RJ45) - RS-485 and Alarm Input...
Page 9
LT0N-U/LT0P-U a Dome camera body b Fall Prevention Wire Be sure to hook the fall prevention wire into a bracket. “A” Caution: When you fix the dome cover to the dome camera body, you must insert the wire in the dome camera body.
Removing the Protection Tape Discuss the installation location for the camera with your retailer, and select a place that is strong enough Model LT303N/P is used for the description, operation for the installation. and details provided in this operating guide.
Mounting the Camera The figures show an example of the camera mounted on a ceiling (LT303N/P/NI/PI) or wall with a locally procured bracket. Note: The camera have not been evaluated for wall or ceiling mounting. Ceiling mount LT0NI/LT0PI LT0NI/LT0PI (Optional)
Page 12
Pendant mount (Optional) Install pipe and camera as shown below. LT0N/P/NI/PI LT0N-U/LT0P-U LT303P-B.HAP_ENG_MFL66987622.ind12 12 2011.1.4 6:48:48 PM...
Page 13
Add thread sealing tape Note: The pipes and brackets for mounting are not supplied. Reference: Specifications of LG Standard pipe. Note: Do not remove the block (A) to keep the gap (B) between the camera body and installation bracket. LT303P-B.HAP_ENG_MFL66987622.ind13 13...
Page 14
Pipe threads should be clean and rust free. Use a sealer (such as Teflon™ tape and silicone sealer) on the threads. Add thread sealing tape Note: The pipes and brackets for mounting are not supplied. Reference: Specifications of LG Standard pipe. LT303P-B.HAP_ENG_MFL66987622.ind14 14 2011.1.4 6:48:50 PM...
(ON OFF OFF OFF) Reserved 12 (OFF OFF OFF OFF) Reserved 13 Note: If you are not using the controller with LG Multix proto- col, there may be some limitation of function control. SW104 Switch position (SW101) Protocol (ON ON ON ON)
The table for the camera ID setting Switch position (SW104) Baud Rate SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 OFF OFF OFF OFF OFF OFF OFF OFF (OFF OFF OFF OFF) 9 600 BPS OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF...
Page 17
OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF...
Page 18
OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF...
Connections Use the cable that is described below for RS-485 site communication. • Shielded, twisted pair cable Model LT303N/P is used for the description, operation and details provided in this operating guide. • Low impedance • Wire gauge size is thicker than AWG #22 (0.33 mm²).
Page 20
Alarm Input function Data Port Adapter This speed dome camera has a terminal that can sense the alarm signals. If the alarm sensor that has installed in a door, win- dow, safe etc. sense a touch or shock, the alarm Alarm sensor send the alarm signal to the camera and the sensors...
Stop auto panning and change Stop operating pattern func- While operating the observe position to the tion and change the observe Auto Pan func- While operating alarmed position then keep position to the alarmed position tion. Pattern function. observe the alarmed position. then restart the pattern function again.
System Connection Connection of the data port and adapter with LKD1000 controller Note: Description Color When any peripheral is turned off and turned on again, the camera is also turned off and turned back TRX D - Orange TRX D + Yellow Caution: Do not connect the alarm connectors to the another...
Operation Main Menu Sub Menu Contents LOW / D/N LEVEL MIDDLE / HIGH 5, 10, 15, Setup Menu Overview DWELL TIME AUTO 30, 60 SEC DAY / NIGHT INITIAL SET RET / TOP The following table shows the list of menu items and EXIT / END options.
We use the LKD1000 controller in this manual to D-EFFECT Not supported. explain the features of the LG Dome camera because COLOR of the LKD1000’s ability to control all of the LG Dome COLOR LEVEL camera’s advanced features. (For detailed controller FREEZE OFF / ON instructions, refer to the LKD1000 Controller Manual.)
General Operation Accessing setup menus To access the setup menus using the keys on a 1. Use [In] or [Out] button to select an option then LKD1000 controller, do the following: press [Open] or [Close] button. 1. Select CAM (Camera) icon in the main menu and Submenu appears on the monitor.
Page 26
Focus Distance setting Zoom Speed setting Selects the minimum shooting distance for the focus. Selects a zoom speed. Select [FOCUS DIST] option on the [FOCUS] menu, Select [ZOOM SPEED] option on the [FOCUS] then select a focus distance value (50 cm, 1 m, 3 m, menu, then select a zoom speed (SLOW, MIDDLE or 5 m).
Exposure settings WDR LEVEL: LOW MIDDLE HIGH BLC: Set the BLC limit. • BLC LEVEL: LOW MIDDLE HIGH Iris setting HSBLC: Use for adjusting brightness the • specific area of picture. The HSBLC mode is automatically activated only in low illuminance scene.
White Balance setting SHUTTER (Shutter Speed) setting Select the desired shutter speed for camera exposure. You can change the shutter speed to higher speed Select the method by which the camera shifts its to capture fast-moving subjects, though the image output colors to compensate for the color of a light becomes darker.
Note: If you set the AGC to [OFF] or the SHUTTER is set to one of the SHUTTER options except AUTO on the [EXPOSURE] menu, the AUTO mode of the DAY/NIGHT function is not avail- able and [---] mark is displayed. DAY: Color mode enabled.
Privacy Mask setting istered mask color will be changed automatically with the same color for each of group (MASK1 to 4, MASK5 to 8). This function is aiming at the protection of personal privacy, selecting a screen part black not to be dis- D-DNR setting played in the screen.
Page 31
D-EFFECT (Digital effect) setting 2. Use [Near] or [Far] button to change a adjust the option. If you set the sharpness value to higher, This model does not support the D-EFFECT function. the image outline becomes sharp. If you set to lower value, the image outline becomes dim.
Language setting User title setting You can use the camera identification to assign a number and character to the camera (0 to 9, A to Z, a Select a language for setup menu and information to z). The USER TITLE is displayed on the upper left display.
Page 33
Reference Specifications LT303N LT303P MODEL NTSC (High Resolution) PAL (High Resolution) Signal System 4.5 mm EX-view HAD CCD Pick-Up Device 410 000 Pixels 470 000 Pixels Total Pixels No Internal Sync System x27 Zoom (F1.5 (Wide End) , F3.6 (Tele End)), f = 3.25 mm to 88 mm Lens More Than 520 TV Lines Horizontal Resolution...
Page 34
LT303NI LT303PI MODEL NTSC (High Resolution) PAL (High Resolution) Signal System 4.5 mm EX-view HAD CCD Pick-Up Device 410 000 Pixels 470 000 Pixels Total Pixels No Internal Sync System x27 Zoom (F1.5 (Wide End) , F3.6 (Tele End)), f = 3.25 mm to 88 mm Lens More Than 520 TV Lines Horizontal Resolution...
Page 35
LT303N-U LT303P-U MODEL NTSC (High Resolution) PAL (High Resolution) Signal System 4.5 mm EX-view HAD CCD Pick-Up Device 410 000 Pixels 470 000 Pixels Total Pixels No Internal Sync System x27 Zoom (F1.5 (Wide End) , F3.6 (Tele End)), f = 3.25 mm to 88 mm Lens More Than 520 TV Lines Horizontal Resolution...