Table of Contents
Advertisement
Checking the
Safety-Interlock Switches
Service Interval: Before each use or daily
The machine has interlock switches in the electrical
system. These switches disengage either the traction
unit or the PTO whenever you leave the seat. If you
disengage the PTO and engage the parking brake
before you leave the seat, the engine continues to run.
1.
Drive the machine slowly to a large, open area.
Lower the cutting unit, shut off the engine, and
apply the parking brake.
2.
Sit on the seat and press the traction pedal. Try
to start the engine. The engine should not start.
If the engine starts, there is a malfunction in the
interlock system that should be corrected before
beginning operation.
3.
Sit on the seat, start the engine, and engage
the PTO. While sitting in the seat with the PTO
engaged, rise from the seat. The PTO should
disengage after a slight delay. If the PTO
remains engaged, there is a malfunction in the
interlock system that should be corrected before
beginning operation.
4.
Sit on the seat, engage the parking brake and
start the engine. Move the traction pedal out of
the N
position. The InfoCenter should
EUTRAL
display "traction not allowed" and the machine
should not move. If the engine does move, there
is a malfunction in the interlock system that
should be corrected before beginning operation.
Adjusting the Mirrors
Cab Model Only
Rearview Mirror
While sitting in the seat, adjust the rearview mirror to
attain the best view out the rear window
Pull the lever rearward to tilt the mirror to reduce the
brightness and glare of light.
Side-View Mirrors
While sitting in the seat, have someone assist to
adjust the side-view mirrors to attain the best view
around the side of the machine
(Figure
34).
(Figure
34).
1. Side-view mirrors
2. Rearview mirror
Aiming the Headlights
Optional Accessory
1.
Loosen the mounting nuts and position each
headlight so that it points straight ahead.
Note:
Tighten the mounting nut just enough to
hold the headlight in position.
2.
Place a flat piece of sheet metal over the face of
the headlight.
3.
Mount a magnetic protractor onto the plate.
4.
While holding the assembly in place, carefully tilt
the headlight downward 3°, then tighten the nut.
5.
Repeat the procedure on the other headlight.
Activating the Quiet Mode
When the machine is in Quiet Mode, the sound
pressure level at the operator's position is less than
80dBA with a K-factor of 1.0 dBA, when evaluated per
EN ISO 5395:2013-1 Annex F.
Contact your authorized Toro distributor to set the
machine software to activate Quiet Mode.
31
Figure 34
3. Lever
g008870
Advertisement
Table of Contents
