Bosch SmartphoneHub CUI100 Original Operating Instructions page 14

English – 12
Inserting the smartphone
3
(18)
(18)
4
Pull the front mounting bracket (18) forward ➋.
Insert the smartphone with the long side of the phone
positioned against the rear mounting bracket (19) ➌.
Allow the front mounting bracket (18) to slide slowly
toward the smartphone and release it ➍.
Power supply for the smartphone (optional)
The smartphone can be supplied with power
(5 V/1 A) using a separate USB cable (included with
delivery) via the micro A/B USB port of the Smart-
phoneHub. To do this, connect the smartphone to the
USB port of the SmartphoneHub using the USB cable.
Note: If the eBike battery reaches a state of charge of
0 %, remove any loads that may be present (e.g.
smartphone).
Removing the smartphone
Use both hands to push the smartphone forward
along with the front mounting bracket until the smart-
1 270 U20 XBC | (16.03.2023)
(19)
2
phone can be removed from the Universal Mount. If
necessary, remove the USB cable for the power sup-
ply.
Software update
If a software update is available for the Smartphone-
Hub, an indicator is shown in the smartphone app.
Follow the instructions in the app to perform the up-
date.
Recovering the SmartphoneHub
A recovery operation should be carried out on the
SmartphoneHub if it is no longer functioning cor-
rectly. To do this, open the app on your smartphone
and follow the instructions.
Power supply for the SmartphoneHub
The SmartphoneHub has an internal lithium-ion poly-
mer battery (nominal/minimum 300 mAh, 3.7 V) that
cannot be removed.
The SmartphoneHub can be switched on via its on/off
button (2) or via the on/off button of the eBike bat-
tery. If the SmartphoneHub cannot be switched on, it
must be charged via a USB cable for at least 30 min-
utes.
If you do not use your SmartphoneHub, recharge the
SmartphoneHub every 3 months. You can charge the
battery of the SmartphoneHub via its USB port with
any power adapter, smartphone charger, etc.
Switching the push assistance on/off
The push assistance aids you when pushing your
eBike. The speed of this function depends on the se-
lected gear and can reach a maximum of 3.7 mph.
The push assistance function must only be used
u
when pushing the eBike. There is a risk of injury if
the wheels of the eBike are not in contact with the
ground while using the push assistance.
To activate the push assistance, briefly press the
WALK button on your operating unit. Once it is acti-
vated, press and hold the + button (14) within
three seconds. The eBike drive is switched on.
Note: The push assistance cannot be activated at as-
sistance level OFF.
Bosch eBike Systems