Attaching An Alternative Anti Tip Device; Preparing To Connect The Water - Bosch B24IW50NSP Installation Instructions Manual

7. Attaching an alternative anti tip
device
!
IMPORTANT NOTE
If possible, always screw the wooden beam to
existing studs on the rear panel of the cavity.
If the anti tip brackets cannot be attached securely,
an alternative anti tip device can be attached.
However, ensure that there is no play between the
appliance and the anti tip device.
Saw the wooden beam (cross section min. 3" x 4")
q
to the required length.
Length is equal to the width of the installation cavity!
Note
i
- If the installation cavity is deeper than the appliance,
select a beam which has a larger cross section or
attach 2 beams.
- The beam must cover the appliance by at least 2"
(50.8 mm).
Mark the installation height (lower edge of the beam)
q
on the rear panel of the cavity.
Select screws according to the thickness of the
q
wooden beam: length = min. 2.5 x beam thickness,
diameter #12 or #14.
Specify the number of screws according to the
i
cavity width, thereby ensuring that the beam can
be attached securely.
24
Locate wall studs near the rear panel of the cavity
q
and mark drill holes in the beam.
Predrill the wooden beam.
q
!
Attach the wooden beam to the rear panel of the
q
cavity.

8. Preparing to connect the water

(only for appliances which require a water connection)
d
Turn off the main water tap to prevent damage
caused by leaking water.
Attach the connecting pipe to the shut off valve
q
according to the instructions supplied by the
manufacturer of the ice maker installation kit.
Install the connecting pipe. Always observe the
q
indicated gap dimensions to prevent damage to the
connecting pipe when pushing in the appliance.
Attach the connecting pipe to the floor with
q
adhesive tape.
Get other manuals https://www.bkmanuals.com
CAUTION
d