Toshiba VFNC3-2001P Instruction Manual page 179

efesotomasyon.com -Toshiba inverter,drive,servo,plc
7.2.2 Output terminal function (sink logic)
This function is used to output a variety of signals to external devices from the inverter.
With the contact output terminal function, you can select from multiple output terminal functions. Set two types of
functions for the OUT terminal and then you can output when either one or both of them is ON.
[Control terminal block]
Usage
FLA, B, C function: Set at parameter .
OUT-NO function: Set at parameter  and .
Assign one type of function to an output terminal
Terminal
Title
symbol
OUT-NO  Output terminal selection 1A
FL
 Output terminal selection 2
(A, B, C)
Note) When assigning 1 type of function to the OUT-NO terminal, set only .
Leave parameter  as the standard setting ( = ).
FLA FLB FLC CC VI
OUT NO CC F R
Function
G-7
P5 FM
S1 S2 P24
FLA
FLB
FL
FLC
OUT
NO
Adjustment range
4 (Low-speed detection signal)
0 ∼ 255
E6581595
7
Standard defaults
10 (fault FL)