16
OVERVIEW
Installing and Getting Ready
Removing the Filter Vinyl
Remove the fi xing tape and the protective vinyl from
the product and the fi lter before use.
Based on the front of the product, hold and
1
gently pull both sides of the air inlet (cover) to
separate it.
• The side with the LG logo on the display of
the product is the front of the product.
Status
Display
Air inlet(cover)
2
Remove the fi lter fi rst, then remove the
protective vinyl.
• When removing the packaged fi lter, hold
the protective vinyl and separate the fi lter.
3
Install the fi lter into the product.
• Make sure that the side with the fi lter
handle is facing upward.
Handle
4
Insert the fi xing part on both sides at the
bottom of the cover into the fi xing groove in
the bottom of the product, and then close the
cover.
CAUTION
• Be sure to remove the protective vinyl from the
fi lter before using the product.
• When installing the fi lter, pay attention to the
direction of the fi lter.
– Failure to do so may cause malfunction or
product failure.
– The part with the fi lter handle is the top side.
SG