Table of Contents
Advertisement
STEP 1: ANPDN/ANPDL
Assign the first digit of the LCR/LCRS access code. When the access code is common to all nodes,
use the ANPDN command. When the access code is assigned for each node, use the ANPDL com-
mand.
TN=1
TN=1
STEP 2: ASPAN/ASPAL
Assign the LCR/LCRS access code for a dummy route number. When the access code is common to
all nodes, use the ASPAN command. When the access code is assigned for each node, use the ASPAL
command.
ACC=8
ACC=8
STEP 3: AMND
Using AMND, assign the Maximum Necessary Digits to be received by Register (ORT) circuit.
DC=8110
STEP 4: ARNPL
Using ARNPL, assign the access code for each external trunk route, but not for a dummy route.
RT=10
RT=200
Note:
When entering the data in STEP 1, 2, 6, 7 and 8, do not mix the commands for LDM and NDM. Write the
data on the same data memory as shown below:
•
When writing the data on the LDM:
ANPDL → ASPAL
(STEP 1)
•
When writing the data on the NDM:
ANPDN → ASPAN → AFRSN → AOPRN → AADCN
(STEP 1)
Note
1st DC=8
CI=N (Normal)
1st DC=8
CI=H (Hooking)
Note
CI=N (Normal)
SRV=LCR/LCRS
CI=H (Hooking)
SRV=LCR/LCRS
MND=8
ACC=8
ACC=9
→ AFRSL → AOPRL → AADCL
(STEP 2)
(STEP 6)
(STEP 2)
(STEP 6)
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
Assignment of FCH Related Data
NND=1
NND=1
LGRT=Dummy route number
LGRT=Dummy route number
(STEP 7)
(STEP8)
(STEP 7)
(STEP8)
DATA PROGRAMMING
CHAPTER 5
Page 91
Revision 3.0
Advertisement
Table of Contents
