Replacing The Power Supply; Replacing The Power Distributor - Bosch DIP-6186-8HD Instruction Manual

DIVAR IP 6000 (2U)
See also
–
10.12.1

Replacing the power supply

The power supply can be replaced without turning off the system if a redundant power supply
is available.
Replacement units can be ordered directly from Bosch RMA desk.
To replace the power supply:
1.
2.
3.
4.
5.
6.
7.
10.12.2

Replacing the power distributor

Redundant chassis that are 2U or greater require a power distributor. The power distributor
provides failover and power supply redundancy.
Bosch Sicherheitssysteme GmbH
Power supply, page 13
You can leave the unit running and remove only one power supply if your chassis includes
a redundant power supply.
Unplug the AC power cord of the failed power supply.
Push the release tab (on the back of the power supply) as illustrated.
Pull the power supply out using the handle provided.
Replace the failed power module with the same model.
Push the new power supply module into the power bay until you hear a click.
Plug the AC power cord back into the module and turn on the unit.
Installation Manual
Maintenance | en 41
2016.08 | V2.1 | DOC