Setting The Alarm Time (Alarm 1 / Alarm 2) - Silvercrest SSRM 10 A1 Manual

SilverCrest SSRM 10 A1
 You can start the station scan or access saved stations even
when the SLEEP timer is activated.
 You can delete the activated SLEEP timer by switching off the
scan radio.

Setting the alarm time (Alarm 1 / Alarm 2)

You can set 2 alarm times. Make sure that the time is set
correctly. You can set the alarm time only when the device is
switched off. Switch off the device with the "On/Standby" button
(6) if it is switched on.
 Briefly press the "MEM/AL" button (7). The display (1)
indicates the "Alarm 1" symbol (12), and when you briefly
press the "MEM/AL" button (7) again, the display (1) indicates
the "Alarm 2" symbol (13).
 Select Alarm 1 or Alarm 2 and briefly press the "MODE"
button (3).
 The hour display flashes and you can then set it by pressing
the "-" button (2) or "+" button (4). Then press the "MODE"
button (3) again. The minute display then flashes and you can
set it by pressing the "-" button (2) or "+" button (4).
 Finally, press the "MODE" button (3) again. The display (1)
then indicates the current time and the alarm you just set is
active. This is indicated by the respective alarm symbol
(12,13) on the display (1).
Proceed in the same manner to set the second alarm.
20 - English