Cab Controls - Toro Groundsmaster 360 Operator's Manual

Power Take Off (PTO) Switch
The power take off (PTO) switch starts and stops the
mower blades (Figure
Steering Selector Switch
Press the steering selector switch to the rear to
engage 4 wheel steering and forward to return to 2
wheel steering (Figure
Power Point
The power point is a 12 volt power supply for
electronic devices (Figure
Important:
If the mower deck shuts down and the
InfoCenter temperature warning icon is on, push
PTO knob down, drive to a safe flat area, move
the throttle lever to the Slow position, allow the
traction pedal to move to the neutral position, and
engage the parking brake. Allow the engine to idle
for several minutes while it cools to a safe level.
Stop the engine and check the cooling system;
refer to Checking the Cooling System.
Fuel Gauge
The fuel gauge (Figure
remaining in the fuel tank.
1. Fuel gauge
4).
4).
4).
5) indicates the fuel level
Figure 5
2. Fuel tank cap

Cab Controls

3
2
1
9
1. Air recirculation control
2. Fan control
3. Temperature control
4. Wind shield wiper switch
Air Recirculation Control
Sets the cab to either recirculate the air in the cabin or
to draw air into the cabin from outside
•
Set it to recirculate the air when using the
air-conditioning.
•
Set it to draw air in when using the heater or fan.
Fan Control
Rotate the fan control knob to regulate the speed of
the fan (Figure
Temperature Control
Rotate the temperature control knob to regulate the
air temperature in the cab
Wind Shield Wiper Switch
Use this switch to turn the wind shield wipers on or
g014170
off (Figure 6).
Power Outlet
Use this 15 amp, 12 V DC power outlet to power
compatible devices
Lights Switch
Use this switch to turn the head lights and tail light
on or off (Figure
Flashers Switch
Use this switch to turn the flashers (hazard lights) on
or off (Figure 6).
14
4
8
Figure 6
5. Power outlet
6. Lights switch
7. Flashers switch
8. Air conditioning switch
6).
(Figure 6).
(Figure 6).
6).
5
6
g028431
7
g028431
(Figure 6).