Settings - Sharp PN-ZB03W Operation Manual

Configure wireless board settings.
TIPS
• A security warning may appear in some web browsers.
Follow the instructions in the web browser and continue the procedure.
1. Start the computer's web browser.
2. Enter the IP address shown on the home screen of Wireless mode in the address bar of the web browser.
The settings screen appears. You can also access the settings screen by clicking the settings button in the connection
software. (See page 19.)
n Download
Quick Executable application
(Guest)
Installer
Download Device Profile
n Conference Control
The password entry screen appears.
Enter the password for Conference Control and click "Login". (The default password is "moderator".)
Display Input
Control
PIP
Allow control from this page
only.
n Admin
The password entry screen appears.
Enter the password for Admin and click "Login". (The default password is "admin".)
After changing the setting, click "Apply".
System Status
Device Setup Device Setup Code
Pairing

settings *

* This setting will be added when the wireless board firmware is updated. (See page 31.)
28
E
Settings
Download the connection software in an executable state.
Installation is not necessary.
Download the installer for the connection software.
After downloading the installer to your computer, install the software.
Download the profile for connection of the wireless board.
If you are using the installed connection software, double-click the profile to connect the
computer to the wireless board from which the profile is downloaded.
You can change the input mode of the monitor. After changing the mode, click "Apply".
You can change the PIP mode of the monitor. After changing the mode, click "Apply".
Use in conference control mode. (See page 22.)
The system state is displayed.
You can check the MAC address.
Set the passcode used to connect to the wireless board.
Disable: Connect to the wireless board without entering a passcode.
Random: The passcode changes.
Use the following code: Fix to the numeric value entered for the passcode.
Apply Controller WLAN settings
Use the wireless board's wireless LAN settings for SSID, encryption, and the key.
Apply the following WLAN settings
Select this to enter the SSID, encryption, and key manually.