Advertisement
12
3.4 Setup, data mapping and typical parameters for ACS880, DCS880
Drive Parameter
Setup parameters
20.01 Start/Stop EXT 1
22.11 Vector Speed Ref
28.11 Scalar Speed Ref
58.01 Comms Protocol
58.03 Node Address
58.04 Baud Rate
58.05 Parity
58.14 Comm Loss Action
58.15 Comm Loss Mode
58.17 Transmit Delay**
ACS880 typical parameters
READ from VFD
58.101 Data I/O 1
58.102 Data I/O 2
58.103 Data I/O 3
58.104 Data I/O 4
58.105 Data I/O 5
58.106 Data I/O 6
58.107 Data I/O 7
58.108 Data I/O 8
58.109 Data I/O 9
58.11 Data I/O 10
58.111 Data I/O 11
58.112 Data I/O 12
Write to VFD
58.113 Data I/O 13
58.114 Data I/O 14
58.115 Data I/O 15
58.116 Data I/O 16
58.117 Data I/O 17
58.118 Data I/O 18
58.119 Data I/O 19
58.12 Data I/O 20
58.121 Data I/O 21
58.122 Data I/O 22
58.123 Data I/O 23
58.124 Data I/O 24
58.06 Comm Control
*58.03 Node Address corresponds to the VFD-GATEWAY Node Settings (see VFD-GATEWAY Settings Web Interface)
**It is recommended to set this to 0 to avoid adding delays to the data
***The VFD-GATEWAY only supports these default settings
For ACS880 and DCS880 the write data starts at 58.113 and First 12 registers must be reads (58.101-58.112)
Note: You MUST set 58.06 to refresh settings after all parameters in group 58 are set.
Example for ACS880, DCS880
Embedded fieldbus
EFB ref1
EFB ref1
Modbus RTU***
Drive 1,2..up to 5 *
38.4 kbps***
8 EVEN 1***
Warning
Any Message
0
Status Word 16 bit
Act 1 16 bit
Act 2 16 bit
1.07 Motor Current
1.11 DC Bus Voltage
1.01 Motor Speed
1.14 Motor Power
1.13 Output Voltage
1.10 Motor Torque
1.06 Output Frequency
1.31 Ambient Temperature
47.21 Data Storage
Control Word 16 bit
Ref 1 16 bit
Ref 2 16 bit
47.21 Data Storage
47.22 Data Storage
47.23 Data Storage
47.24 Data Storage
23.14 Acceleration time 2
23.15 Deceleration time 2
22.26 Constant Speed 1
22.27 Constant Speed 2
22.28 Constant Speed 3
Refresh Settings
LVD-EOMU02U-EN REVD 11/2022
Advertisement
