Table of Contents
Advertisement
9 Timer
You can set the time on the timer. Once this time has
elapsed, a signal tone sounds. You can set a maximum
time on the timer of 24 hours.
The function works independently of the operation and
other time-setting options. The timer signal is different
from other signals.
9.1 Set the timer
1.
Press
.
a The display shows the timer.
2.
Use the control ring to set the timer duration.
3.
Press
.
The timer also starts automatically after a few
seconds.
a The timer counts down.
a After a short time, the display switches back.
a In addition, a timer symbol is shown on the display.
10 Basic settings
You can configure the basic settings for your appliance
to meet your needs.
10.1 Changing basic settings
Requirement: The appliance is switched off.
1.
Press and hold for approx. 3 seconds.
a The display shows information about the process.
2.
Use
to confirm this information.
a The first setting "Language" appears on the display.
3.
Turn the control ring to change the setting as re-
quired.
4.
Press
.
a The next setting appears on the display and you can
use the control ring to change it.
5.
Use
to work through all of the information and, if
required, use the control ring to make changes.
6.
To save changes, press and hold for approx. 3
seconds.
a The display shows a notification confirming that the
settings have been saved.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
10.2 Discarding changes to the basic
settings
▶
Press
.
a All changes are discarded and not saved.
a Once the timer duration has elapsed, a signal tone
sounds.
4.
Press
to end the signal tone early.
9.2 Changing the timer
1.
Press
.
a The display shows the timer.
2.
Use the control ring to change the timer duration.
Note: If an operating mode with a set duration is run-
ning, this duration is highlighted. You can use
lect the timer. The timer duration is highlighted for a
short time. You can change the timer duration.
9.3 Cancelling the timer
▶
Reset the timer duration.
a Once this is implemented, the symbol no longer
lights up.
10.3 Overview of the basic settings
This is where you can find an overview of the basic set-
tings and factory settings. The basic settings depend
on the features of your appliance.
Notes
¡ Changes to the language, button tone and display
brightness settings take effect immediately. All other
settings do not take effect until you save them.
¡ Your changes to the basic settings will be retained
even after a power failure. Only the settings pertain-
ing to the initial start-up of the appliance need to be
implemented once again following a power failure.
→ "Initial use", Page 8
Basic settings Selection
Language
Set "Language"
Time
Set "Time "
Audible signal
Short cooking time
Medium cooking time
Long cooking time
Button tone
Switched off
Switched on
Display bright-
The display brightness can be adjus-
ness
ted in 5 settings
Setting 3
Clock display
Switched on
Switched off
Night-time dim-
Switched off
ming
Switched on (display dimmed
between 10 p.m. and 6 a.m.)
1
Factory setting (may vary according to model)
Timer en
to se-
1
1
1
1
1
13
Advertisement
Table of Contents
