Safety instructions en Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power ■ that the back of the cable. dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface).
en Safety instructions Also follow the installation Please note that the ■ ■ instructions for the insulation material of the dishwasher to ensure that all dishwasher power cord may appliances are operated melt next to heat sources safely. (e.g. heating / hot water If there is no information or if installations) or hot ■...
Safety instructions en Childproof lock (door lock) * Open the door with activated T he child-proof lock (door lock) child-proof lock (door lock) as D o o r l o c k protects children from potential follows: Press the catch of the hazards which the dishwasher child-proof lock to the right poses.
en Safety instructions Childproof lock (button lock) Damage Y ou can prevent your The appliance may be B u t t o n l o c k dishwasher being switched off ■ repaired and opened up by a inadvertently (e.g. by children technician only.
Page 9
Safety instructions en Do not lean or sit on the Keep children away from ■ ■ open door. detergents and rinse aid. In the case of free-standing These may cause chemical ■ appliances, ensure that the burns in the mouth, throat baskets are not overloaded.
en Environmental protection Environmental Getting to know your protection appliance B oth the packaging of new appliances D iagrams of the control panel and the E n v i r o n m e n t a l p r o t e c t i o n G e t t i n g t o k n o w y o u r a p p l i a n c e and the old appliances themselves interior of the appliance can be found at...
Getting to know your appliance en Appliance interior 9" Dispenser for rinse aid 9* Detergent dispenser See Fig. ~ Page 2 92 Lock for detergent dispenser 9: Rating plate 1" Interior light * 1* Cutlery drawer * * depending on the features of your 12 Top basket dishwasher 1: Upper spray arm...
en Water softening system/special salt Adjusting the water softening Water softening system system / special salt You can set the amount of salt that should be added to a value between T o ensure good rinsing results, the •:‹‹ and •:‹ˆ. No salt is needed with W a t e r s o f t e n i n g s y s t e m / s p e c i a l s a l t dishwasher requires soft water, i.e.
Water softening system/special salt en Using special salt Using detergent with a salt component Top up the special salt as soon as the I n general, you can use detergent with salt refill indicator ` lights up in the D e t e r g e n t w i t h a s a l t c o m p o n e n t a salt component up to a water control panel.
en Rinse aid Add rinse aid up to the max. mark. Rinse aid The rinse aid ensures stain-free dishes R i n s e a i d and clear glasses. Use only rinse aid for domestic dishwashers. As soon as the rinse aid refill indicator h lights up in the control panel, there is still a rinse aid reserve of 1-2 rinse cycles.
Rinse aid en Setting amount of rinse aid Using detergent with a rinse aid component You can set the amount of rinse aid that I n general, you can use detergent with should be added to a value between D e t e r g e n t w i t h a r i n s e a i d c o m p o n e n t a rinse aid component up to a water §:‹‹...
en Utensils Loading the dishwasher Utensils Remove large food remnants. It N ot suitable is not necessary to prerinse utensils U t e n s i l s under running water. Cutlery and utensils made of wood. Place the utensils so that ■...
Utensils en Cutlery basket * P lace cutlery, always unsorted with the C u t l e r y b a s k e t tips face down, in the cutlery basket *. To prevent injuries, place long, pointed implements and knives on the knife shelf *.
en Utensils Adjust the height of the etagere as follows: Position the etagere vertically and pull upwards. Push etagere at a slight angle downwards to the required height (1, 2, or 3). Engage etagere. Etagere “clicks” into position. Folding spikes * * Depending on the features of your F o l d i n g s p i k e s dishwasher, the spikes can be folded...
Utensils en Small items holder * Baking sheet spray head * * Depending on the features of your * depending on the features of your S m a l l i t e m s h o l d e r B a k i n g s h e e t s p r a y h e a d dishwasher, the upper basket is fitted dishwasher...
en Utensils Unloading the dishwasher Adjusting the height of the basket * To prevent water from dripping off the * depending on the features of your upper basket onto the utensils in the A d j u s t i n g t h e h e i g h t o f t h e b a s k e t dishwasher lower basket, it is recommended to empty the appliance from the bottom...
Page 21
Utensils en To lift the upper basket; grip the sides of the upper basket along the upper edge and lift. Ensure that both sides of the upper basket are at the same height. Push in upper basket. Upper basket with upper and lower pairs of rollers Pull out upper basket 12.
en detergent Adding detergent Detergent If the detergent dispenser 9* is still Y ou can use tablets as well as powder closed, actuate locking bar 92 to d e t e r g e n t or liquid detergents for dishwashers, but open it.
detergent en If the utensils are only lightly If programmes are short, tablets may Tip: ■ soiled, slightly less than the indicated not have full cleaning effect due to amount of detergent is usually different dissolving properties and adequate. there may even be undissolved Suitable detergents and care products detergent residue.
en Overview of programmes Overview of programmes T he max. possible number of programmes is illustrated in this overview. The O v e r v i e w o f p r o g r a m m e s corresponding programmes and their arrangement can be found on the fascia.
Overview of programmes en Type of dish Type of soiling Programme Possible Programme additional sequence options Time-optimised: part dried, common Cleaning 65° Œ mixed utensils and Extra Dry household food Intermediate rinse cutlery Shine and Dry 65° remnants Final rinse 70° Drying sensitive utensils, Time-optimised:...
en Additional functions Ï intensiveZone * Additional functions P erfect for a mixed load. You can wash i n t e n s i v e Z o n e very soiled pots and pans in the lower * Depending on the features of your A d d i t i o n a l f u n c t i o n s basket together with normally soiled dishwasher, you can select different...
Operating the appliance en Eco drying Operating the If you have selected the Eco 50° appliance programme, the door opens automatically when the programme P rogramme data ends. This ensures a particularly O p e r a t i n g t h e a p p l i a n c e economical drying result.
en Operating the appliance Switching on the appliance Remaining running time display Turn tap fully on. Switch on ON/OFF switch (. When the programme is selected, the The Eco 50° programme has been remaining programme time is indicated preset for environmentally friendly in the display window )".
Operating the appliance en Auto Power Off (Automatic Here is how to change the setting: Switch on the ON/OFF switch (. switch-off after end of Hold down the programme button programme) or interior # and then repeatedly press the lighting * START button P until •:‹...
en Operating the appliance Switching off the appliance Interrupting the programme Shortly after the end of the Caution! Expansion (overpressure) may cause programme: Switch off ON/OFF switch (. the appliance door to jump open and/or Turn off water supply (does not water to escape! If the door was opened apply to appliances with Aqua-Stop).
Operating the appliance en Changing the programme ExtraDry When the START button P has been The final rinse uses a higher pressed, the programme cannot be temperature which improves the drying changed. The only way a programme result. The running time may increase can be changed is by Cancel slightly.
en Cleaning and maintenance Notes Cleaning and Only clean the appliance with ■ special detergents/appliance maintenance cleaners which are suitable for use with dishwashers. A regular inspection and maintenance Regularly wipe the door seals using C l e a n i n g a n d m a i n t e n a n c e ■...
Cleaning and maintenance en ‰ Special salt and rinse aid Machine Care M achine Care used in combination with Top up the salt and/or rinse aid as soon M a c h i n e C a r e commercially available machine as either of the refill indicators on the cleaning detergent is a suitable control panel ` or h lights up.
en Cleaning and maintenance Filters Spray arms The filters 1Z keep large foreign Limescale and contaminants in the objects in the rinsing water away from rinsing water may block nozzles and the pump. hese foreign objects may bearings on the spray arms 1: and occasionally block the filters.
Fault, what to do? en Clean the waste water pump as Fault, what to do? follows: Disconnect the dishwasher from the E xperience has shown that you can power supply. F a u l t , w h a t t o d o ? rectify most faults which occur in daily Take out top basket 12 and bottom operation yourself.
en Fault, what to do? Fault table Fault Reason Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display lights up. Tap turned off. Turn on water supply. Tap jammed or calcified. Turn on water supply. Flow rate must be at least 10 l/min.
Page 37
Fault, what to do? en Fault Reason Remedial action Fault code “:ƒ… is lit. Waste-water hose kinked or Install hose without kinks, remove any blocked. residue. Siphon connection still sealed. Check connection to siphon and open if required. Cover on the waste water pump Lock cover correctly.
Page 38
en Fault, what to do? Fault Reason Remedial action Utensils not dry. Not enough rinse aid in the Refill rinse aid. dispenser, or none at all. Programme without drying was Select programme with drying. selected. ~ "Overview of programmes" on page 24 Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 39
Fault, what to do? en Fault Reason Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 40
en Fault, what to do? Fault Reason Remedial action Detergent residue Detergent dispenser cover 9* Utensils must not be placed above the blocked by utensils and therefore tablet collecting tray 1B. These may does not open fully. block the lid of the detergent dispenser and prevent it from opening fully.
Page 41
Fault, what to do? en Fault Reason Remedial action White, stubborn coatings; Detergent substances are Change detergent brand. limescale on the utensils, deposited. These coatings cannot Clean appliance mechanically. container or door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according to water hardness greater than 8.9...
Page 42
en Fault, what to do? Fault Reason Remedial action Plastic parts discoloured. Too low rinsing temperature. Select programme with higher washing temperature. Utensils precleaned too intensely; Do not prerinse utensils. Remove only sensors therefore decide on large food remnants. weak programme sequence. Increase sensitivity of the sensors.
Page 43
Fault, what to do? en Fault Reason Remedial action Appliance cannot be Malfunction. Disconnect appliance from the power switched on or operated. supply; pull out the mains plug or switch off the fuse. Wait at least 5 seconds, then connect the appliance to the power supply.
Page 44
en Fault, what to do? Fault Reason Remedial action Door cannot be closed. Door lock has been activated. Close door with increased force. Door cannot be closed due to Check appliance installation: Door or installation. attached parts must close without obstruction.
Customer service en Customer service Installation and connection I f you are unable to rectify the fault, C u s t o m e r s e r v i c e please contact your customer service. T he dishwasher must be connected We will always find an appropriate I n s t a l l a t i o n a n d c o n n e c t i o n correctly, otherwise it will not function...
en Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions thoroughly in the factory to ensure that can be found in the installation it is in working order. This may cause instructions. Level the appliance with small water stains.
Installation and connection en Drinking water connection Warm water connection* * depending on the configuration of Fasten the drinking water connection H o t w a t e r c o n n e c t i o n your specific dishwasher to the tap according The dishwasher can be connected to to the installation instructions using...
en Installation and connection Electrical connection Removal Connect the appliance to an Also observe ■ alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz Disconnect the appliance from the via a correctly installed socket with power supply.
Installation and connection en Transporting Protection against frost I f the appliance is in a room where Empty the dishwasher and secure loose P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e ) there is a risk of frost (e.g.