Troubleshooting - Silvercrest SDI 2800 A1 Operating Instructions Manual

Troubleshooting

PROBLEM
The appliance is not
working. The indicator
light above the ON/OFF
button fails to come on.
The appliance does not
start the cooking process.
E0 is shown on one of the
displays / .
E2 is shown on one of the
displays / .
E3 is shown on one of the
displays / .
E4 is shown on one of the
displays / .
E6 is shown on one of the
displays / .
SDI 2800 A1
POSSIBLE CAUSE
The plug is not connected.
The appliance is damaged.
There is no vessel on the
respective hob / .
The vessel is not suitable
for induction hobs.
There is no vessel on the
respective hob / .
The temperature sensor
beneath the hob /
defective or there is a short
circuit.
The appliance is being
supplied with too much
voltage (>270 V).
The appliance is not being
supplied with enough voltage
(<150 V).
The appliance has overheated.
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
Contact the Customer
Service department.
Place a suitable vessel on
the respective hob
Use a suitable vessel
(see the "Suitable
cookware" section).
Place a suitable vessel on
the respective hob
Disconnect the plug from
is the mains power socket
and contact the Customer
Service department.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50 Hz.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50 Hz.
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
GB
IE
CY
/ .
/ .
15