LG PQNFB17C0 Installation & Owner's Manual page 82

72
FUNCTIONAL SPECIFICATIONS ACP BACnet
Remarks
• SetTempStatus-XXX / SetLowerTempStatus_XXX / RoomTemp_XXX
1. This object reports the room temperature data measured by the indoor units.
• StartStopCommand_XXX
1. The command executed is transmitted to the indoor unit regardless of the status of the indoor
unit.
2. The Present_Value property will not be used if a property has never been set in the past.
• FanSpeedStatus_XXX
1. The Present_value property will be set to "1:Low" as the default value if the property has never
been set in the past.
• SetUpperTempStatus_XXX
1. This object reports the set upper temperature data measured by the indoor units.
• MalfunctionCode_XXX
1. This object's error code descriptions should be referred to the corresponding table at the
"Reference LG original Error Code".
• ModeCommand_XXX
1. The Present_Value property will be set to "1: Cool" as the default value if property has never
been set in the past.
2. The indoor unit will ignore the command to an object that does not have right to select operation
mode. Therefore, the controlled/monitored system must not use this object for the indoor unit
without the right to select operation mode.
• FanSpeed Command_XXX
1. The indoor unit will disregard the command which the object which can't select the operation
mode. Therefore, controlled/monitored system shouldn't use the object which can't select the
operation mode.
• SetUpperTempCommand_XXX / SetLowerTempCommand_XXX
1. The approximate set upper(or lower) temperature range is 18 ~ 30 °C.
2. 1 °C is detected.