Stopping Boat; Stopping Engine; Procedure; Trimming Outboard Motor - Yamaha FL200C Owner's Manual

Operation
EMU31743

Stopping boat

EWM01511
WARNING
 Do not use the reverse function to slow
down or stop the boat as it could cause
you to lose control, be ejected, or im-
pact the steering wheel or other parts of
the boat. This could increase the risk of
serious injury. It could also damage the
shift mechanism.
 Do not shift into reverse while traveling
at planing speeds. Loss of control, boat
swamping, or damage to the boat could
occur.
The boat is not equipped with a separate
braking system. Water resistance stops it af-
ter the throttle lever is moved back to idle.
The stopping distance varies depending on
gross weight, water surface conditions, and
wind direction.
EMU27822

Stopping engine

Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU31832

Procedure

1. Turn the main switch to "
OFF
50
" (off).
ON START
ZMU04599
ON
OFF OFF
2. Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to " " (off).
EMU27863

Trimming outboard motor

EWM00741
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
ON
ZMU05833