Suspension Settings
Front/Rear Spring Preload Adjustment
The factory setting is appropriate for nearly all riding conditions. If
desired, the suspension may be adjusted to maintain vehicle clearance
height when carrying loads.
To adjust the preload, do the following:
1. Elevate the vehicle to allow the suspension to fully extend.
2. Turn the adjusting ring to the left to increase preload for a higher
ride height. Turn the adjusting ring to the right to decrease preload
for a lower ride height.
Model
RZR XP
RZR XP EPS
RZR XP 4 EPS
Follow these guidelines if you make adjustments to this suspension.
• Always return the suspension to the factory setting after the load is removed
from the vehicle. The increased suspension height will negatively impact
vehicle stability when operating without a load.
• Always apply the same adjustment setting to all four wheels.
Do not increase the spring preload by more than one inch (25.4 mm) over the
factory setting.
Factory Preload Settings
Location
Front
Rear
Front
Rear
Front Left
Rear
MAINTENANCE
Measurement
0.80" (20 mm)
7.97" (202 mm)
0.80" (20 mm)
7.97" (202 mm)
2.04" (51 mm)
5.13" (130 mm)
113