Table of Contents
Advertisement
2.3 Module Installation
Install the module according to the following procedure:
(1) Match the guides at top and bottom of the base and insert the module vertically on
the base.
(2) Pass an M3 screw through the hole at the top and bottom of the module and
secure the base and the module (recommended torque: 1.47N•m=15kgf•cm).
Remove the module according to following procedure:
(1) Turn off the power supplied to the model 3000. Turn off the external power to the
I/O module.
(2) Detach cables from the module.
(3) Remove the screw at the top ando bottom of the module.
(4) Pull the entire module vertically from the base to remove the module.
• Tighten the screws securely so that they do not become loose with vibration.
They can cause injuries if they become loose and fall off.
• Always turn off the power before removing/installing the module.
Removing or installing the module with the power on can cause malfunction or
operation errors.
• The device will not operate normally if installed where there is no station bus
connecter.
• Do not touch the C3 module when the power is on. The heat radiating side covers
become extremely hot (ambient temperature+20
(ambient temperature+10
6E8C1118
CAUTION
o
C) in 10 minutes when the power is turned off.
2.3 Module Installation
o
C) when power is on. It cools
15
Advertisement
Table of Contents
