Table of Contents
Advertisement
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1.
Move the transport lock to the lock position.
2.
Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inch) cutting height
position) as shown in
3.
To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
25).
4.
Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin
(Figure
5.
Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
Figure 25
1. Deck-lift pedal
2. Cut-of-height pin
Figure
25.
(Figure
25).
3. Transport lock
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
26,
Figure
1. Anti-scalp roller
2. Spacer
3. Bushing
g027343
1. Anti-scalp roller
2. Bushing
26
27, and
Figure
28.
Figure 26
4. Flange nut
5. Bolt
Figure 27
3. Flange nut
4. Bolt
Figure
g029955
g029956
Advertisement
Table of Contents
