Advertisement
5
Mounting
1
Please use a connecting wire (accessory) and an interconnecting cable (procured locally)
to connect to indoor unit terminal board cable.
If crimping tools are not available, please use other reliable methods for connection.
Do not only use the insulating tape to connect; otherwise it can be dangerous.
Since the Leak Detector cable has no polarity that is OK if the indoor unit's terminal A and
terminal B are inversely connected.
Terminal block
for remote controller
cable in indoor unit
Interconnecting cable
(Procured Locally)
• Use non-polarity 2-core cable.
• Use 0.5 mm
2
Remove rear cover from body to refer to the step 1 to 3 shown as below figure.
Keep screw and body until process 5.
Step 3 : Unlock the upper hook
to pull the body
A
B
Connecting
section
- 2.0 mm
cable.
2
2
Side hook
Step 2
Leak Detector
W
B
Connecting wire
(Accessory)
W : White
B : Black
Upper hook
Side hook
Rear cover
Step 2 : Unlock the side hook
Leak Detector Body
Step 1: Remove the bind screw
12
12-EN
Advertisement
