Using The Imagepress Server; Starting, Shutting Down, Rebooting, And Restarting - Canon imagePRESS P400 Service Manual

Using the imagePRESS Server

This chapter describes how to use the imagePRESS Server.

Starting, shutting down, rebooting, and restarting

Always use the following procedures to start, shut down, reboot, or restart the imagePRESS Server.
IMPORTANT:
Always verify that the imagePRESS Server is not in use before you power off or restart it. Make sure that the system is not
processing or printing a job. Before you take the imagePRESS Server off the network, always obtain permission from the
network administrator.
■ Start the imagePRESS Server
1. Press the power switch to set ON (|).
2. Power on the printer using the main power switch.
The imagePRESS Server will automatically turn on as the printer warms up.
If it has been enabled in Setup, the imagePRESS Server Start page will also print automatically when the imagePRESS
Server is ready for use.
NOTE:
If the imagePRESS Server does not start up within 15 minutes, see the Startup section of
79.
■ To shut down the imagePRESS Server
1. Make sure that the imagePRESS Server is not receiving, processing, or printing any jobs.
2. Make sure that the printer is not in use.
3. Power off the printer using the main power switch on the front.
The imagePRESS Server will automatically start the shutdown process. Wait for the printer and the imagePRESS Server to
power off completely.
4. Move the imagePRESS Server power switch to the OFF (O) position.
Figure 1: Starting the imagePRESS Server
11
2. Using the imagePRESS Server
"If the printer does not print" on page