Beko HCG 61320 X User Manual
Hide thumbs Also See for HCG 61320 X:

Advertisement

Quick Links

Hood
User Manual
HCF 61620 X
HCF 91620 X
HCG 61620 X
EN
01M-8805473200-4918-02
HCG 91620 X
HCG 61320 X
HCG 71320 X

Advertisement

Table of Contents
loading

Summary of Contents for Beko HCG 61320 X

  • Page 1 Hood User Manual HCF 61620 X HCG 91620 X HCF 91620 X HCG 61320 X HCG 61620 X HCG 71320 X 01M-8805473200-4918-02...
  • Page 2 Please read this manual first! Dear Customers! Thank you for selecting a Beko product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product and keep it as a reference for future use.
  • Page 3: Table Of Contents

    CONTENTS 1 Important safety and environmental instructions 1.1 General safety ......6 1.2 Compliance with WEEE Directive and dispo- sing of the waste product.
  • Page 11: Important Safety And Environmental Instructions

    Important safety and environmental instructions Closely follow the instructions set • Note: the elements marked with out in this manual. All responsibility, the symbol “(*)” are optional for any eventual inconveniences, accessories supplied only with damages or fires caused by not some models or elements to complying with the instructions in purchase, not supplied.
  • Page 12 Important safety and environmental instructions • The premises where the appliance • For lamp replacement use only is installed must be sufficiently lamp type indicated in the ventilated, when the kitchen Maintenance/Replacing lamps hood is used together with other section of this manual. gas combustion devices or other •...
  • Page 13 Important safety and environmental instructions • Use the correct length for the screws which are identified in the The symbol on the product, or Installation Guide. on the documents accompanying the product, indicates that this • In case of doubt, consult an appliance may not be treated authorised service assistance as household waste.
  • Page 14: Compliance With Weee Directive And Dispo

    Important safety and environmental instructions • EMC: EN 55014-1; CISPR 14-1; 1.2 Compliance with WEEE Directive and disposing of the EN 55014-2; CISPR 14-2; EN/IEC waste product 61000-3-2; EN/IEC 61000-3-3. Suggestions for a correct use in This product complies with EU WEEE order to reduce the environmental Directive (2012/19/EU).
  • Page 15: Use

    2.2 Filter version The hood is designed to be used either for exhausting or filter version. One active charcoal filter is needed for this and can be obtained from your usual retailer. The filter 2.1 Ducting version removes the grease and smells from the extracted In this case the fumes are conveyed outside of the air before sending it back into the room through building by means of a special pipe connected with...
  • Page 16: Installation

    Installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 65 cm from electric, gas or mixed cookers. If the instructions for installation for the hob specify a greater distance, this must be adhered to.
  • Page 17: Mounting

    Mounting Before beginning installation: • In addition check whether near the installation area of the hood (in the area accessible also with • Check that the product purchased is of a suitable the hood mounted) an electric socket is available size for the chosen installation area.
  • Page 18: Cleaning And Maintenance

    Cleaning and maintenance 6.1 Cleaning 6.1.3 Washable activated charcoal filter The cooker hood should be cleaned regularly (at least with the same frequency with which you The charcoal filter can be washed once every two carry out maintenance of the fat filters) internally months using hot water and a suitable detergent, and externally.
  • Page 19: Maintenance

    Cleaning and maintenance 6.2 Maintenance ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
  • Page 20 www.beko.com...

Table of Contents