14 Installing the VPT300
3
Install the crimping cover.
4
Install the rear cable cover.
Insert the crimping cover into the
bottle gourd–shaped mounting pegs.
Tighten the captive screws.
Insert the dowel into its hole.
53
DANGER
When mounting the rear
access panel onto the rack,
watch your hands.
NOTE
After the installation is
complete, remove the
protective film from the lens
of the dual-camera system.
5
Install the rear access
panel.
1. Ensure that all
required cables are
installed.
2. Insert the two dowels
on the rear access
panel into the dowel
holes on the rack, and
push the panel up until
it is secure.
The following figure
shows the appearance
of the rear access
panel.