Bosch 0 601 9C3 300 Original Instructions Manual page 21

Wet/dry dust extractor
– Dust extractor
– Turbine
A)
Max. volume flow rate
– Dust extractor
– Turbine
Max. suction power
Area of pleated filter
Dust class
Weight according to EPTA-Pro-
cedure 01:2014
Protection class
Protection rating
A) Measured using a vacuum hose 3 m long and 35 mm in diameter
The specifications apply to a rated voltage [U] of 230 V. These spe-
cifications may vary at different voltages and in country-specific mod-
els.
Values can vary depending upon the product and are subject to ap-
plication and environmental conditions. For further information
www.bosch-professional.com/wac.
Automatic start/stop
Rated voltage Maximum power Minimum power
230 V 2200 W
Permitted connected load of the connected power tool.
These values can differ for other country-specific models. Please take
note of the information on the socket of the dust extractor.
Noise/Vibration Information
Noise emission values determined according to
EN 60335-2-69.
Typically the A-weighted sound pressure level of the dust ex-
tractor is 70 dB(A). Uncertainty K = 3 dB. The noise level
when working can exceed 80 dB(A).
Wear hearing protection
Total vibration values a (triax vector sum) and uncertainty K
h
determined according to EN 60335-2-69: a
2
K = 1.5 m/s .
Assembly
Pull the plug out of the socket before cleaning or per-
u
forming maintenance on the vacuum cleaner, making
tool adjustments, changing accessories or putting
away the vacuum cleaner. This safety measure prevents
the vacuum cleaner from being started accidentally.
Fitting the holder for the vacuum hose (see
figure A)
– Slide the holder (4) for the vacuum hose firmly into the
corresponding adapters (36) from above until they click
into place.
Bosch Power Tools
Fitting the vacuum hose (see figure B)
GAS 55 M AFC
– Attach the vacuum hose (27) to the hose adapter (3) and
hPa 230
turn it clockwise as far as it will go.
hPa 254
Note: The friction generated by the dust in the vacuum hose
and accessory during extraction causes an electrostatic
l/s 36
charge that the user may experience as static discharge (de-
pending on environmental factors and their physiological
m³/s 0.036
state).
l/s 74
Bosch generally recommends using an anti-static vacuum
m³/s 0.074 hose (accessory) to vacuum up fine dust and dry materials.
W 1,380
Fitting the vacuuming accessories (see figure C)
m² 0.615
The vacuum hose (27) is equipped with a clip system which
M
can be used to connect vacuuming accessories (dust extrac-
kg 16.2
tion adapter (25), curved nozzle (28)).
Fitting the nozzles and tubes
/I
– Push the curved nozzle (28) onto the vacuum hose (27)
IPX4
until you hear both snap fasteners (37) on the vacuum
hose engage.
– Then attach the required extraction accessory (floor
nozzle, crevice nozzle, suction tube, etc.) firmly to the
curved nozzle (28).
– To remove the accessory, press the snap fasteners (37)
inwards and pull apart the components.
Fitting the dust extraction adapter
– Push the dust extraction adapter (25) onto the vacuum
hose (27) until you hear both snap fasteners (37) on the
100 W
vacuum hose engage.
– To remove the adapter, press the snap fasteners (37) in-
wards and pull apart the components.
Inserting/removing the disposal bag or dust bag
(dry extraction) (see figure D)
A disposal bag (29) or dust bag must be used for the dry ex-
traction of dust class M materials.
Insofar as materials with or without an exposure limit of
≥ 1 mg/m
be sucked straight into the container.
Note: If using a paper filter bag, you must make sure that
2
<2.5 m/s ,
h
automatic filter cleaning (AFC) is switched off; you should
also do the same if using a fleece filter bag (see " Automatic
filter cleaning (see figure I)", page 23).
WARNING
Emptying and maintenance procedures, including the
disposal of dust containers, should only be carried out by
professionals. Suitable protective equipment is re-
quired. Do not operate the vacuum cleaner unless the
complete filter system is correctly inserted. Otherwise,
you are putting your health at risk.
Inserting the disposal bag
– Open the catches (15) and remove the top part of the va-
cuum cleaner (13).
3
(dust class L materials) are extracted, these can
The dust extractor contains dust
particles that pose a risk to health.
1 609 92A 7Z9 | (15.02.2023)
English | 21