Transport inspection
Storage
Storage and transport
temperature
Lifting and carrying
Display and adjustment
module
External display and
adjustment unit
Flanges
Rod components
Centering
10
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
•
Not in the open
•
Dry and dust free
•
Not exposed to corrosive media
•
Protected against solar radiation
•
Avoiding mechanical shock and vibration
•
Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
•
Relative humidity 20 ... 85 %
With instrument weights of more than 18 kg (39.68 lbs) suitable and
approved equipment must be used for lifting and carrying.
3.4
Accessories
The instructions for the listed accessories can be found in the down-
load area on our homepage.
The display and adjustment module LG Local Display Interface is
used for measured value indication, adjustment and diagnosis.
The LG Remote Interface is an external display and adjustment unit
for sensors with single chamber housing and Ex d double chamber
housing.
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, BS 10, ASME B 16.5,
JIS B 2210-1984, GOST 12821-80.
If you are using an instrument with rod version, you can extend the
rod probe individually with curved segments and rod and cable exten-
sions of different lengths.
All extensions used must not exceed a total length of 6 m (19.7 ft).
The extensions are available in the following lengths:
Rod: ø 16 mm (0.63 in)
•
Basic segments: 20 ... 5900 mm (0.79 ... 232 in)
•
Rod/cable segments: 20 ... 5900 mm (0.79 ... 232 in)
•
Curved segments: 100 x 100 mm (3.94 ... 3.94 in)
If you mount the SITRANS LG260 in a bypass tube or standpipe, you
have to avoid contact to the bypass tube by using a spacer at the
probe end.
SITRANS LG260 - Operating Instructions
PBD-51041061