Collecting A Final Diagnostic - Hitachi 3090 G2 Hardware Reference Manual

f. Set the Data bits to 8.
g. Set the Stop bits to 1.
h. Set the Parity to None.
i. Set the Flow Control to None.
j. Click Session in the Category Tree on the left.
k. Enter SMU serial (or similar) in the Saved Sessions box.
l. Click Save.
3. Turn on the putty session logging.
a. Click Logging from the Category Tree on the left.
b. Select Printable output in Session logging.
c. Set the location for the putty output file.
d. In the section What to do if the log file already exists, select Ask the user
every time.
e. Click Session from the Category Tree on the left, which returns you to the
Session window.
f. Click Save.
4. Click Open to open the session to the Node console.
a. Login as Username: manager Password:nasadmin
5. Type the command ipaddr and verify that you are connected to the correct node.
6. Perform ONLY ONE of the following procedures.
If the node firmware is below 11.1.3225.02, perform the following procedure:
■
a. Type the command: new-battery-fitted --field --confirm
b. Once the prompt returns, press: <ctrl>+d to exit out of BALI into the Linux
Layer.
c. Type su to change the login to root.
d. Password: nasadmin.
e. Restart the chassis monitor by issuing the command: /etc/init.d/
chassis-monitor restart
f. Type scc localhost to return to the Bali prompt.
If the node firmware is at or later than 11.1.3225.02 then perform the following
■
procedure:
a. Type the command new-battery-fitted --field --confirm
7. Check the Battery Status.
a. Type the command batt-log-show; the output should show that the battery
is fitted and initialization has started.
b. If the battery is not showing fitted or initialization does not start, call the GCC
to open a SR for resolution.

Collecting a final diagnostic

Collect a final diagnostic as the last step in battery replacement.
Hitachi NAS Platform 3080 and 3090 G2 Hardware Reference
Chapter 6: Replacing server components
Collecting a final diagnostic
58