Table of Contents
Advertisement
Handling of the Command Line Interface (CLI)
Listing for concatenated command input
m o d e m # s h s ?
s t a r t u p - c o n f i g s t i c k - c o n f i g s y s t e m
m o d e m # s h s
2.2.5
Operation modes - View (login) and configuration (enable)
The management console of the EDS500 500FSD20 modems has a two-level access concept:
• view mode
• operation mode configuration
Most of the system parameters can be shown in view mode whereas safety critical settings are
excluded.
The view mode is accessed with a successful login. Depending on the user authentication scheme
(refer to Chapter 2.3, "User authentication") a login name and/or a login password have to be
entered.
In operation mode configuration all system parameters can be shown and all commands for system
configuration can be executed. The operating mode configuration is accessed at the management
console with the command <enable> after login to the command line interface (CLI).
Depending on the set user authentication scheme (refer to Chapter 2.3, "User authentication") a
login name and/or a login password have to be entered for the operating mode configuration.
The command <disable> terminates operation mode configuration. Afterwards, the device is in view
mode.
Login-
Password
Figure 1: Access modes
The command <exit> terminates view mode and operating mode configuration and closes the
command line interface (CLI).
The prompt at the command line interface (CLI) shows the current access mode:
Prompt for view mode
m o d e m >
The symbol > indicates the login permission (view mode).
Prompt in operation mode configuration
m o d e m #
10
View
Mode
Password
Mode
Enable-
< enable >
< disable >
Functions
Configuration
Mode
1KGT151043 V001 1
Advertisement
Table of Contents
