Canon imagePASS-R1 Service Manual page 66

2. If possible, print the Configuration pages (see
The Configuration pages contain a list of any installed options and a record of the customer's current Setup configuration.
3. If you are reinstalling the same version of system software, back up the current system configuration (see
up the system configuration" on page
4. Shut down the imagePASS
Leave the imagePASS power switch in the ON (|) position.
5. Power off the printer using the main power switch.
The imagePASS will automatically shut down.
6. Move the imagePASS power switch to the OFF (O) position.
7. Disconnect all external cables from the imagePASS, except the power cable and the printer interface cable.
NOTE:
Be sure to leave the power cable connected between the imagePASS and the power outlet.
8. Flip the service switches to boot mode (set the switch 1 to ON; switch 2 to OFF).
NOTE:
The LED display is mounted in upside-down orientation.
No.
1 Service switches
2 LED display
3 Flip the service switches from normal (OFF OFF) position...
4 ...to service mode (ON) position.
9. Attach the prepared USB flash drive to one of the USB connectors on the imagePASS.
NOTE:
If dust covers are attached to the USB connectors, remove dust cover using needlenose pliers.
10. Power on the imagePASS by pressing the power switch to set ON (|), and then power on the printer using the main
power switch on the front.
Make sure that the imagePASS turns on.
"Printing the Configuration pages" on page
47).
(see"Starting, shutting down, rebooting, and restarting the imagePASS" on page
1
Figure 30: Service switches on the imagePASS
4. INSTALLING SYSTEM SOFTWARE
3
2
4
Name
61
67).
"Backing
11).