Uniform Call Distribution (Ucd)-Pri - NEC NEAX 2400 IPX Programming Manual

UNIFORM CALL DISTRIBUTION (UCD)-PRI

U-6 UNIFORM CALL DISTRIBUTION (UCD)-PRI
1. General Description
This feature distributes incoming calls from ISDN trunk to a specified group. Calls are distributed to idle
stations, in a circular pattern, in the order they arrive.
2. Operating Procedure
No manual operation is required.
3. Programming
STEP 1: ASHU - Assign the required data for the UCD group:
STEP 2: ANPD - Reserve a number level for feature access. Assign Connection Indexes of Normal and
STEP 3: ASPA - Assign an access code to UCD BUSY OUT. SRV = SSCA, SIDA = 50 BUSY OUT set,
STEP 4: AKYD - Assign BUSY OUT set/cancel key (same key does both; toggles function on/off). Assign
STEP 5: ATRF - Assign Traffic Measurement Order.
CHAPTER 5
Page 158
Revision 1.0
TN: Tenant Number
STN: Station Number
CNT: Number of stations to be entered (Recommended Max. of 20 stations for the
release 1/2, Max. of 100 stations for the release 3 or higher)
STN: Station Numbers of the stations included in the UCD group.
(The order in which stations are programmed is the order in which they will be
hunted.)
momentary switchhook flash (Hooking). Assign NND in accordance with a predetermined
numbering plan.
SRV = SSCA, SIDA = 51 BUSY OUT cancel. Connection Status Indexes CI = N, Normal
and CI = H, hooking.
KYI = 1, FKY = 19. Assign UCD Call Waiting Indication key. Assign KYI-1, FKY-47.
TYPE: Type of Traffic Measurement (1-16)
INTERVAL: Output Interval must be assigned in units of ten minutes (range is from 30-
120 minutes), or data "0" must be assigned, which is the instruction for
assigning output time.
FROM-TO-: Measurement time is to be designated.
TIME: Output Time
TYPE: 1-10
1: Terminal Traffic Measurement
2: Route Traffic Measurement
3: Station Peg Count
4: Attendant Console Peg Count
5: Route Peg Count
6: Service Peg Count
7: Terminal Peg Count
8: UCD Route Peg Count
9: UCD Group Peg Count
10: UCD Station Peg Count
NDA-24305