Cutting Unit 1 (Center), Which Includes Reel Motor; Cutting Unit 2 (Left), Which Includes Reel Motor; Check The Cutting Unit And The Reel Motor For Any Mechanical Resistance, And Make Sure That The Reels Are Free Of Any Foreign Debris. Remove Any Debris That Is Found - Toro Greensmaster TriFlex 3300 Manual

1. Go to Preparing for Troubleshooting and/or Testing (page 20)
2. Disconnect the 48 V power to the cutting reel motors. Refer to
V Power to the Cutting Reel Motors (page
3. Refer to Figure 21

1. Cutting unit 1 (center), which includes reel motor 1

2. Cutting unit 2 (left), which includes reel motor 2

4. Check the cutting unit and the reel motor for any mechanical resistance, and make sure that the reels are
free of any foreign debris. Remove any debris that is found.
5. Check for proper bedknife adjustment and the overall condition of the reel. Adjust the bedknife if it is out of
alignment (Refer to the applicable Cutting Unit Operator's Manual listed in
(page 8)).
6. Connect 48 V power to the cutting units. Refer to
Cutting Reel Motors (page
7. Operate the machine.
Pass The fault did not repeat. Go to
Fail The fault repeated. Go to Step 3.
Step 3: Swap cutting reel motors between cutting units.
All of the cutting reel motors are identical.
1. Verify that 48 V power has been disconnected from the cutting units. Refer to
Disconnecting the 48 V Power to the Cutting Reel Motors (page
2. Swap cutting reel motor 2 with a cutting reel motor from a different cutting unit. Refer to the Greensmaster
TriFlex 3320/3420 Service Manual, Chapter 6, Service and Repairs section, Cutting Reel Motor.
3. Connect the 48 V power to the cutting reel motors. Refer to
to the Cutting Reel Motors (page
4. Operate the machine.
to locate cutting unit 2.
18).
Returning the Machine to Service (page 21)
18).
and follow the steps listed.
Connecting and Disconnecting the 48
18).
Figure 21
3. Cutting unit 3 (right), which includes reel motor 3
Connecting and Disconnecting the 48 V Power to the
18).
Connecting and Disconnecting the 48 V Power
36
External Reference Material
and follow the steps listed.
Connecting and
g225145