Installing the System Board
To install the system board, follow the steps below and refer to Figure 4-29.
1.
Seat the system board. First set the edge along the computer port side, then lay
the board into place.
2.
Seat the AC PS unit support and secure seven M2.5x6 screws.
3.
Seat the battery terminal cover and secure it with one M2.5x6 screw.
4.
Install the AC PS unit, HDD interface board, FDD, top cover with display
assembly, RTC battery, sub-battery, VGA assembly, keyboard, HDD, optional
memory module, optional PC card, and battery pack as described in Sections 4.11
back through 4.2.
110 Series
4-31