Notice For Maintenance And Inspection - Acer ATL 1840E Operation Manual

4.6 Notice for maintenance and inspection

Execute an emergency stop or switch off the main power supply before carrying
out maintenance and inspection work. If the machine is still in an operable
condition during this work and for example, a sensor is inadvertently touched,
the machine may move due care is therefore required. Before operating the
machine, make sure that there is no obstacle to motion in the vicinity of the
machine.
1) Maintenance and inspection work must be performed without tail in order to
keep the machine operating at its highest performance and make it safe to
operate at all times.
2) Device maintenance and inspection plan and carry it out on a regular basis.
3) Proceed with maintenance and inspection as planned even if this interferes
with the production plan.
4) Before starting on the maintenance and inspection work, turn the power
switch off.
5) When working inside the electric control cabinet or repairing the machine, set
the power switch to the OFF position and lock it.
6) Do not use air to clean the machine. This may cause dust or sand particles to
cover the bearing or slide ways.
7) Use only lubricating oils which are recommended by + -
In order to operate machine correctly and make the most of machine's functions
and performance, all operators must thoroughly understand the machine.
To keep the machine operating at its highest level, it must be inspected every
day. If an abnormality is discovered during daily inspection, it must be
reported to the supervisor and the person responsible for machine
maintenance.
Quick action should be taken. For problems that cannot be repaired by the user
or those for which the cause cannot be isolated, contact your + - service
representative.
Daily Replenishing Oil and Inspections by the machine Operator
Maintenance and Repairs by maintenance Mechanics
Service Request Call to our Representative
↓
↓
Page 4-7