Using The Control Panel - ABB ACS560 Quick Installation And Start-Up Manual

￭

Using the control panel

1 Clip – Press the clip downward to remove the panel from the drive.
2 Display – Shows basic home view 1 by default. See parameter 49.19 Basic panel
home view 1.
3 RJ-45 connector slot – Located on the back side of the control panel.
4 Back button – Moves back to the previous menus. In the Home screen, this button
navigates to the Options menu.
5 OK button – Confirms the selected action.
6 Status LEDs –
• Continuous green – Indicates that drive is functioning normally.
• Blinking green – Indicates an active warning in the drive.
• Continuous red – Indicates an active fault in the drive.
7 Arrow buttons – Allows scrolling up/down/left/right on text pages. In the Home
screen, the left and right arrow buttons navigate to different (default or user-
defined) home screens (see parameter 49.19 , 49.20 and 49.21 ).
8 Start button– Starts the drive.
9 Stop button – Stops the drive.
10 Loc/Rem button – Switches between Local/Remote controls. Local control is
through control panel and Remote control is through PC or external devices.
EN - Quick installation and start-up guide 35
1
2
3
4
6
7
9
10
5
8
EN
HI