Table of Contents
Advertisement
Hard drive
Description
500 GB, 7200 rpm, 2.5 inch, self-encrypting (SED)
500 GB, 7200 rpm, 2.5 inch
320 GB, 7200 rpm, 2.5 inch
256 GB Solid-state Drive (SSD), self-encrypting (SED)
128 GB Solid-state Drive (SSD), self-encrypting (SED)
64-GB, flash, MLC, 2.5-inch
32-GB, flash, MLC, 2.5-inch
CAUTION:
transfer the data to the new drive.
1.
Turn off the computer properly through the operating system, then turn off any external devices.
2.
Disconnect the power cord from the power outlet.
CAUTION:
the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to
the internal components of the computer.
3.
Remove the front panel
4.
Press in the release latch on the left side of the hard drive carrier (1) and then rotate the carrier handle
up (2).
36
Chapter 5 Removal and replacement procedures
If you are replacing a hard drive, be sure to back up the data from the old drive so that you can
Regardless of the power-on state, voltage is always present on the system board as long as
(Front panel on page
31).
Advertisement
Table of Contents
