Cmms More Messages To Send; Cmod Call Mode - Nokia 6090 Command Manual

+CMMS More Messages to Send

+CMOD Call Mode

Nokia 6090 AT Command Set
Response:
+CMGW: <index>
Monitor Log from above example:
AT+CMGF=1;+CMGW="+499501231234"
> hello Nokia
+CMGW: 4
OK
AT+CMGL
List all SMS!
Response:
+CMGL: 1,"STO UNSENT","+499501231234",,
abcdefghi
+CMGL: 2,"STO UNSENT","+499501231234",,
abcdefghi
+CMGL: 3,"STO UNSENT","+499501231234",,
abcdefghi
+CMGL: 4,"STO UNSENT","+499501231234",,
hello Nokia
OK
This command controls the continuity of SMS relay protocol link. If enabled (and
supported by network), several consecutive messages can be sent (+CMGS etc.)
much faster as link is kept open.(GSM 07.05)
Syntax:
AT+CMMS=<n>
AT+CMMS?
AT+CMMS=?
Parameters:
<n>:
0
1
2
This command sets the call mode for further dialling command ATD or for next
answering command ATA . To prevent the possibility that alternating mode calls are
originated or answered accidentally, <mode> is automatically reset to value 0 after
each call. Note that alternating call-answering operations from an external UI may
change +CMOD values. (GSM 07.07).
Syntax:
AT+CMOD=[<mode>]
AT+CMOD?
AT+CMOD=?
Values for <mode>:
0
1
You have successfully stored a message.
Default option is 0.
Query current setting.
Response is +CMMS: <n>
Show supported values.
Response is +CMMS: (list of supported
<n>'s)
Disable. Default option
Keep enabled until time between
message send commands exceeds five
seconds (then switch <n> back to 0),
Enable (this affects also 07.05 block
mode).
Set call mode. Default option is 0.
Query current setting.
Response is +CMOD:<mode>.
Show supported modes.
Response is +CMOD: (list of supported
<mode>'s).
single mode (default)
alternating voice/fax (teleservice 61)
32